Assemble - Taylor-Dunn SC-011-59 Operation, T Roubleshooting And Replacement Parts Manual

Transmission

Assemble

1. Thoroughly clean all gasket surfaces.
2. Apply a 1/8" bead of 94-430-03 gasket sealer to the
face of the 3rd member.
3. Install the backing plate to the 3rd member. Torque
to 30-45 ft-lbs.
4. Install the motor to the backing plate. Do not fully
tighten the mounting hardware at this time.
5. Install the motor sprocket, drive sprocket and chain.
Do not adjust the chain tension at this time.
6. Apply a 1/8" bead of 94-430-03 gasket sealer to the chain case
housing.
7. Install the chain case centering tool (refer to
Appendix A) into the pinion seal bore
in the chain case housing.
8. Install the chain case housing
onto the pinion shaft and
tighten the pinion nut to 75
ft-lbs.
Apply sealer around the ID of the holes
9. Install and tighten the three nuts and washers to
the threaded studs and the housing bolts that are
not used for the brake mounting bracket or
alignment brackets.
10. Remove the centering tool and install a new pinion
seal. Lightly lubricate the pinion seal lip.
11. Install the brake assembly and the brake band
alignment bracket(s). Do not tighten the bolts at this
time.
12. Install the brake drum. Torque to 175 ft-lbs.
Transmission Page 12