Installing The Software Driver For Windows Nt - Adaptec AAA-130U2 Installation And Hardware Manual

Installing the Software
Driver for Windows NT
In this Chapter
Installing the Array1000U2 Driver for Windows NT
Windows NT Installation and Configuration Notes
This chapter explains how to install the AAA-131U2/133U2 soft-
ware driver ( cda1000.sys ) for Windows NT (Windows NT 4.0
Server and Workstation). Before installing the driver, make sure you
have completed the following:
Installed the AAA-131U2/133U2 in your system.
(See Chapter 2)
Created the first array using the ARRAYCONFIG U2 utility, if
you plan to boot from an array. (See Chapter 3)
Once Windows NT and the driver are installed, install
Adaptec CI/O Management Software and use it to add, delete, and
manage arrays from the server console (CI/O is required for array
management in order to provide the proper level of fault tolerance
and event notification). Refer to the Adaptec CI/O Management Software
User's Guide for instructions on installing and using the software.
é
4-2
4-5
4-1