Upgrading Windows Nt To Windows 2000 - Adaptec 2025ZCR Installation Manual

Upgrading Windows NT to Windows 2000

In this scenario, you already have an Adaptec RAID controller
installed in your system. However, because you are upgrading to a
new operating system, you need to put the correct driver into the
new operating system. To install the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive.
b
Start from the CD. The CD loads a Linux kernel that is used
to manage all of its functions.
c
Follow instructions and respond to prompts as necessary to
get to the Adaptec splash screen.
d
When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
2
Shut down the system and remove the Adaptec RAID
Installation CD.
3
Restart the system.
4
Click the Windows Start button, select Run, and type
a:\w2kprep.exe
5
Remove the driver disk.
6
Insert the Windows 2000 CD and run the
Setup copies some files and then restart the system.
.
Installing the Driver
program.
setup.exe
3-5