Table of Contents
Advertisement
3
Press S to skip autodetection of your SCSI host adapter.
4
Press S again to specify an additional device.
5
Press Enter to select Others; insert the Adaptec Array100
Family Manager Set drivers diskette in your floppy disk drive.
6
The screen displays the adapter drivers supported on the
diskette. Select the Adaptec Array1000CA Family Adapter and
press Enter.
7
If you want to add drivers for other host adapters (other than
the ARO-1130CA), do so at this time by pressing S and repeat-
ing Step 5 for each additional adapter and inserting the appro-
priate disk provided by the hardware manufacturer.
8
Press Enter to continue with the Windows NT operating
system setup. Follow the onscreen instructions in the Windows
NT documentation to complete the installation.
Installing the Driver When Windows NT is Already Installed
To update or install the cda1000.sys driver if Windows NT is
already installed, follow the instructions below.
Updating Windows NT 4.0
To install the cda1000.sys driver when Windows NT 4.0 is already
installed, follow these steps:
1
Start Windows NT.
2
Click the Start button on the Windows NT task bar, and then
point to Settings.
3
Click the Control Panel.
4
Double-click the SCSI Adapters icon.
5
Click the Drivers tab, and then click the Add button.
6
In the Install Driver window, click the Have Disk button.
7
Insert the Adaptec Array1000CA Family Manager Set drivers
diskette into drive A; enter the following path to the installa-
tion files and then click OK.
a:\winnt
The Adaptec Array1000CA Family Adapter is highlighted by
default.
Installing Software on a Windows NT System
4-3
Advertisement
Table of Contents
