Possible Dangers Caused By The Drilling- Milling Machine; Personnel Qualification; Target Group - Optimum OPTimill MB 4 Operating Manual


normal trade coolants/lubricants are used for hard materials.
1.5

Possible dangers caused by the drilling- milling machine

The drilling- milling machine was built using state-of-the-art technology.
Nevertheless, there is a residual risk as the drilling- milling machine operates with

high speeds,

circulating parts and tools and

electrical voltage and currents.
We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the drilling-milling machine is used and maintained by personnel who are not duly
qualified, there may be a risk resulting from incorrect or unsuitable maintenance of the drilling-
milling machine.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
Always disconnect the drilling- milling machine from the electrical power supply before perform-
ing cleaning or maintenance tasks.
WARNING!
The drilling- milling machine may only be operated with functional safety devices.
Disconnect the drilling- milling machine immediately, whenever you detect a failure in
the safety devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices.
This is your responsibility as the operator!

Safety devices on page 13
1.6

Personnel qualification

1.6.1

Target group

This manual is addressed to

operators,

users and

maintenance personnel.
Therefore, the warning notes refer to both, operation and maintenance personnel of the drill-
ing- milling machine.
WARNING!
Always disconnect the drilling- milling machine from the electrical power supply. This will pre-
vent it from being used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The user must have been instructed by the operator about the assigned tasks and possible
risks in case of improper behaviour. The user may only carry out tasks that exceed normal
operation if this is stated in these instructions and the operator has explicitly entrusted him with
the task.
EN MB4
10 Translation of original instruction Version 1.1.1 - 2021-1-25