Table of Contents
Advertisement
WARNING!
Do not use an drill chuck for milling tools. Never clamp a milling cutter into an drill
chuck. Use a collet chuck and the corresponding collets for the end mill.
When milling make sure that
the corresponding cutting speed is selected,
for workpieces with normal strength values, e.g. steel 18-22 m/min,
for workpieces with high strength values 10-14 m/min,
the pressure is selected in a way that the cutting speed remains constant,
for hard materials commercial cooling / lubricating agents are used.
1.5
Possible dangers caused by the drilling-milling machine
The drilling-milling machine was built using the latest technological advances.
Nonetheless there remains a residual risk, since the drilling-milling machine operates with
at high speeds,
with rotating parts and tools,
with electrical voltages and currents.
We have used construction resources and safety techniques to minimize the health risk to per-
sons resulting from these hazards.
If the drilling-milling machine is used and maintained by personnel who are not duly qualified,
there may be a risk by the drilling-milling machine resulting from incorrect operation or
unsuitable maintenance.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,
strictly follow these operating instructions.
Always disconnect the drilling-milling machine from the electrical power supply when perfor-
ming cleaning or maintenance works.
WARNING!
The drilling-milling machine may only be used with functional safety devices.
Disconnect the drilling-milling machine immediately, whenever you detect a failure in the
safety devices or when they are not fitted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices.
This is your responsibility being the operating company!
Safety devices on page 10
there may be a risk to the staff,
there may be a risk to the drilling milling machine and other material values,
the correct function of the drilling-milling machine may be affected.
1.6
Qualification
1.6.1
Target group private users
The machine can be used in the private domain. The acumen of people in the private sector
with training in metal working was taken into consideration for creating this operation manual.
Vocational training or further instruction in a metal working profession is a prerequisite for safe
operation of the machine. It is essential that the private user is aware of the dangers involved in
operating this machine. We recommend visiting a training course in the operation of milling
Safety
Version 1.4.3 - 2020-12-14
Translation of original instruction
BF16V
EN
9
Hide quick links:
Advertisement
Table of Contents
