Appendix 8.1 Copyright; Terminology/Glossary - Optimum OPTimill MB 4 Operating Manual

8 Appendix
8.1 Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2

Terminology/Glossary

Term
Milling table
Taper mandrel
Workpiece
Draw-in rod
Drill chuck
Collet
Drill-mill head
Spindle sleeve
Milling spindle
Drilling table
Taper mandrel
Quill lever
Quick action - drill chuck
Workpiece
Tool
Version 1.1.1 - 2021-1-25
Explanation
Supporting surface, clamping surface for the workpiece with traverse in
X and Y directions
Tool housing taper, drill taper, drill chuck taper.
piece to be milled, drilled or machined.
Threaded rod to fix the taper mandrel in the quill.
Drill bit adapter
Holder for end mill
Upper part of the milling machine
Hollow shaft in which the milling spindle turns.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill bit adapter can be fixed by hand.
Part to be drilled, part to be machined.
Milling cutter, drill bit, etc.
Translation of original instruction
MB4 EN
61