Possible Dangers Caused By The Drilling-Milling Machine; Qualification Of Personnel; Target Group - Optimum Optimill BF 30V Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
1.5

Possible dangers caused by the drilling-milling machine

The drilling-milling machine was built using the latest technological advances.
Nonetheless there remains a residual risk, since the drilling-milling machine operates with

at high speeds,

with rotating parts and tools,

with electrical voltages and currents.
We have used construction resources and safety techniques to minimize the health risk to per-
sons resulting from these hazards.
If the drilling-milling machine is used and maintained by personnel who are not duly qualified,
there may be a risk by the drilling-milling machine resulting from incorrect operation or unsuita-
ble maintenance.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

strictly follow these operating instructions.
Always disconnect the drilling-milling machine from the electrical power supply when perform-
ing cleaning or maintenance works.
WARNING!
The drilling-milling machine may only be used with functional safety devices.
Disconnect the drilling-milling machine immediately, whenever you detect a failure in the
safety devices or when they are not fitted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices.
This is your responsibility being the operating company!

"Safety devices" on page 12
1.6

Qualification of personnel

1.6.1 Target group

This manual is addressed to

the operating companies,

the users,

the staff for maintenance works.
Therefore, the warning notes refer to both, operation and maintenance staff of the drilling-mill-
ing machine.
Disconnect the drilling-milling machine always from the electrical power supply. This will pre-
vent it from being used by unauthorized staff.
The qualifications of the staff for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond the opera-
tion in the standard mode must only be performed by the operator if it is indicated in these
instructions and if the operating company expressively commissioned the operator.
GB BF30Vario
Page 10 Original operating instructions
Safety
Version 1.1.5 dated 2015-08-31