SAV 876.17
1 INTRODUCTION
1. INTRODUCTION
These instructions are intended for manufacturers, installers, operating companies and for the operating and main-
tenance personnel of systems into which this device is installed. The instructions are part of the scope of delivery of
the control unit.
These operating instructions contain information on areas such as the technical data, safety, correct and proper use
as well as operation and maintenance with reference to the control unit.
However, they also contain some information about potential risks in combination with the higher level machine
and the electric permanent magnet used. The objective is to enable the person/company assembling and
operating the overall machine to identify possible risks in the operation of the overall machine
which arise from the actuation of the magnets via the control unit and the parameterisation of the system.
Subject to technical modifications.
NOTE!
Store the operating instructions freely accessible, ready to hand at the place
of use of the control unit. The operating instructions must be read, under-
stood and applied by each person tasked with the following work on the
control unit:
Transport and installation
■
Assembly and commissioning
■
Operation
■
Maintenance and repairs
■
Decommissioning and disposal
■
NOTE!
These instructions become part of the set of documents which also contains
the documents for the higher level system parts and machines and applies in
combination with these.
[
70
]
Version 1.0