Table of Contents
Advertisement
30/ENGINE - WORK ON INDIVIDUAL PARTS
Removing the main bearing of the right engine case section
20.2
–
After the engine case section has cooled, check that the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it is likely that they will
rotate in the engine case when warm. In this case, the engine case must be
renewed.
–
Mount and tighten bearing retainers
Guideline
Screw, bearing retainer
–
Mount and tighten jet
Guideline
Jet 140
–
Mount and tighten oil jets
Guideline
Oil jet
–
Mount the dowels.
200440-10
–
Mount studs
Guideline
Stud, chain shaft
–
Blow compressed air through all oil holes and check that they are clear.
200442-10
–
Remove the screws and take off bearing shell bracket
200435-10
–
Mark face
200436-10
.
M5
.
M6x0.75
.
M6x0.75
.
of the main bearing shells as shown in the figure.
Loctite
®
6 Nm
(4.4 lbf ft)
4 Nm
Loctite
®
(3 lbf ft)
4 Nm
Loctite
®
(3 lbf ft)
M6
8 Nm (5.9 lbf ft)
.
94
243™
243™
243™
Advertisement
Table of Contents
