Changing The Fuses Of Individual Power Consumers - KTM 1190 RC8 EU 2008 Repair Manual

11/WIRING HARNESS, BATTERY

Changing the fuses of individual power consumers

15.5
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Info
The fuse box containing the fuses of individual power consumers is located under the seat.
–
Switch off all power-consuming components and switch off the engine.
–
Remove the seat. (
–
Open fuse box cover
700281-01
–
Check the fuses.
Info
A defective fuse is shown by a burned-out fuse wire
–
Remove the defective fuse.
Guideline
Fuse 1 - 10A - ignition, combination instrument, immobilizer, alarm system
(optional)
700282-01
Fuse 2 - 15A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 3 - 10A - horn, brake light
Fuse 4 - 10A - radiator fan
Fuse 5 - 10A - fuel pump
Fuse 6 - 10A - ignition/fuel injection
Fuse 7 - not used
Fuse 8 - 10A - for supplementary equipment (standard accessories)
Fuse 9 - 10A - for supplementary equipment (accessories connected to the igni-
tion switch)
Fuse 10 - not used
Fuse SPARE - 10A/15A - spare fuses
–
Use spare fuses with the correct rating only.
Fuse (75011088010) (
Fuse (75011088015) (
Info
If the new fuse burns out after it is inserted, it is important that you contact
an authorized KTM-RC8 workshop.
Tip
Replace the spare fuse in the fuse box so that it is available if needed.
–
Close the fuse box cover.
–
Fit the seat. (
p. 32)
.

p. 168)
p. 168)
p. 32)
52
.
