Installing The Front Valve Cover; Installing The Rear Valve Cover - KTM 1190 RC8 EU 2008 Repair Manual

30/ASSEMBLING THE ENGINE

Installing the front valve cover

21.46

Installing the rear valve cover

21.47
–
Remove special tool
Guideline
Plug, crankshaft retainer
200310-11
–
Position the valve cover seal.
–
Put the valve cover in place with the seal. Mount and tighten screws
Guideline
Screw, valve cover
Info
The front valve cover is not equipped with a connector for the engine vent.
–
Mount and tighten the spark plug using a special tool.
200324-11
Spark plug wrench (75029172000) (
–
Mount ignition coil
–
Position the valve cover seal.
–
Put the valve cover in place with the seal. Mount and tighten screws
Guideline
Screw, valve cover
Info
The rear valve cover is equipped with a connector for the engine vent.
–
Mount and tighten the spark plug using a special tool.
200307-11
Spark plug wrench (75029172000) (
–
Mount ignition coil
. Mount and tighten screw

M8
M6
p. 202)
.

M6
p. 202)
.

.

15 Nm
(11.1 lbf ft)
.

10 Nm (7.4 lbf ft)
.

10 Nm (7.4 lbf ft)
141