Installing The Oil Filler Tube; Installing The Starter Motor; Checking The Rear Valve Clearance - KTM 1190 RC8 EU 2008 Repair Manual

30/ASSEMBLING THE ENGINE

Installing the oil filler tube

21.40

Installing the starter motor

21.41

Checking the rear valve clearance

21.42
–
Mount the oil filler tube with the O-ring.
–
Mount and tighten screws
Guideline
Remaining engine screws
200313-10
–
Grease O-ring
Long-life grease (
200312-10
–
Mount and tighten screw
Guideline
Screw, starter motor
200311-11
–
Remove special tool
–
Crank the engine several times.
–
Set the engine to ignition top dead center of the rear cylinder. (
200328-10
–
On all valves, check the valve clearance between the camshaft and cam lever.
Guideline
Valve clearance
Exhaust at: 20 °C (68 °F)
Intake at: 20 °C (68 °F)
Feeler gauge (59029041100) (
200482-10
» If valve clearance does not meet specifications:
–
Adjust the rear valve clearance. (
.

M6
. Mount the starter motor.

p. 194)
with the ground wire.

M6
.

p. 196)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 78)
0.25... 0.30 mm (0.0098...
0.0118 in)
0.10... 0.15 mm (0.0039...
0.0059 in)
p. 140)
139