Oil And Oil Filter Change - Triumph Street Triple S Owner's Handbook Manual

Hide thumbs Also See for Street Triple S:
Table of Contents

Advertisement

Start the engine and run at idle for
approximately five minutes.
Stop the engine, then wait for at least
three minutes for the oil to settle.
Note:
An accurate indication of the level
of oil in the engine is only shown
when the engine is at normal
operating
motorcycle is upright (not on the
side stand) and when the dipstick
has been screwed fully home.
Do not add oil through the dipstick
hole in the crankcase.
Remove the dipstick.
The oil level is indicated by lines on the
dipstick. When full, the indicated oil level
must be level with the upper marking on
the dipstick.
If the oil level is below the lower
marking, remove the filler plug and add
oil a little at a time through the filler
plug hole in the clutch cover until the
correct level is reached.
Once the correct level is reached, fit and
tighten the filler plug.
temperature,

Oil and Oil Filter Change

2
the
1
cjxt
1.
Oil drain plug
2.
Oil filter
The engine oil and filter must be
replaced in accordance with scheduled
maintenance requirements.
Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis. In addition,
used
engine
contamination that can lead to skin
cancer.
protective clothing and avoid skin
contact with used oil.
Warm up the engine thoroughly, and
then stop the engine and secure the
motorcycle in an upright position on
level ground.
Place an oil drain pan beneath the
engine.
Maintenance
Warning
oil
contains
Always
wear
harmful
suitable
131

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents