Brakes; Front Brake Wear Inspection - Triumph Street Triple S Owner's Handbook Manual

Maintenance

Brakes

Front Brake Wear inspection

Brake pads must
accordance with scheduled requirements
and replaced if worn to, or beyond the
minimum service thickness.
1. Carrier plate
2. Brake pad
Model Carrier
plate
minimum
thickness
Street 4.0 mm
Triple S and
Street
Triple S
660cc
Street 4.0 mm
Triple R
and Street
Triple R -
LRH (Low
Ride
Height)
Street 4.8 mm
Triple RS
142
be inspected
Minimum Minimum
lining service
thickness thickness
(lining and
carrier
plate)
1.5 mm 5.5 mm
1.5 mm 5.5 mm
1.0 mm 5.8 mm
If the lining thickness of any pad is less
than that specified in the table, replace
all the pads on the wheel.
in
If fitting new proprietary brand brake
pads, check that the carrier plate of
the brake pad is the specified thickness
shown in the table.
Fitting brake pads with the carrier
plate less than the specified thickness
may result in brake failure due to the
possible loss of the brake pad as it
wears.
Brake pads for this model supplied by
Triumph will have the carrier plate at
the recommended thickness. Always
have replacement brake pads supplied
and fitted by your Triumph dealer.
chbe_1
1. Carrier plate
2. Brake pad lining
Warning
1
2