Triumph Street Triple S Owner's Handbook Manual page 25

Hazard Warning Lights
To turn the hazard warning lights
on or off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
High Beam Switch
When the ignition is switched
ON and the headlight dip switch is set to
HIGH BEAM, the high beam warning
light will illuminate.
Daytime Running Lights (DRL)
When the ignition is switched
ON and the daytime running lights
switch is set to DAYTIME RUNNING
LIGHTS, the daytime running lights
warning light will illuminate.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 88.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the
Lights when dark, in tunnels or where
poor ambient light is apparent may
reduce the riders vision or dazzle other
road users.
Dazzling other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
Note:
• During daylight hours the Daytime
Running Lights
motorcycles visibility to other road
users.
• Low beam headlights must be used
in any other conditions unless the
road conditions allow for high beam
headlights to be used.
Low Fuel Light
The low
illuminate when there are approximately
4.5 litres of fuel remaining in the tank.
Instruments
Daytime Running
improve the
fuel indicator will
25