Setting up a wired network connection
Use a network cable to connect your SendPro C Lite, SendPro C, SendPro+ device to the Pitney Bowes
Data Center.
First, determine the connection type:
1. Tap Settings on the toolbar.
2. Tap Wired.
3. Check the selected connection type.
4. If your connection type is DHCP, follow the steps for DHCP. If your connection type is Static IP,
follow the steps for Static IP.
DHCP
1. Select DHCP.
2. Tap Connect.
3. If it does not connect, unplug the power cord.
4. Wait 2 minutes. The screen should turn off after 10 seconds.
5. Plug the power cord back in directly into a wall outlet.
6. Quickly tap and release the power button to turn the device back on.
7. Tap Settings on the toolbar.
8. Tap Wired (Ethernet).
9. Tap the DHCP radio button.
10. Tap Connect.
Pitney Bowes
Operator Guide
February 2021
Connectivity information
46