Connectivity Information; Setting Up A Wired Network Connection - Pitney Bowes SendPro C Operator's Manual

Setting up a wired network connection

For information about the connection settings required on your network, contact your IT department.
Once you have set up your connection, you can test the connection using the Check Network
application. The icon for this application is located in the application drawer at the bottom of the Home
screen. Refer to Related topics
First, determine the connection type:
1. Tap the Settings (gear) icon in the global toolbar.
2. Tap Wired.
3. Check to see which connection type is selected.
4. If your connection type is DHCP, follow the steps below under DHCP. If your connection type is
Static IP, follow the steps below under
DHCP
1. Select DHCP.
2. Tap Connect.
3. If it does not connect, unplug the power cable.
4. Wait 2 minutes. The screen should turn off after 10 seconds.
5. Plug the power cable back in, ensuring that it is plugged directly into a wall outlet.
6. Quickly tap and release the power button to turn the meter back on.
7. Tap the Settings (gear) icon in the global toolbar.
8. Tap Wired (Ethernet) and make sure DHCP is selected.
9. Tap Connect.
Static
1. Select Static.
2. Contact your internal IT department to get and record the values you will need to enter for your
meter. These include: IP Address, Netmask, Gateway and DNS Address.
3. Enter the values you recorded in step 2 for the IP Address, Netmask, Gateway, and DNS
Address in the corresponding fields.
4. Tap Connect.
5. If it fails to connect, remove the network cable from the back of the meter.
6. Tap the Connect button. Wait for the attempted connection to fail.
7. Plug the network cable back in.
Pitney Bowes Operator Guide
Static IP.
July 2019

Connectivity information

19