12.8
Installing the fork legs
12.9
Removing the lower triple clamp
Main work
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red
adjuster). The compression damping is located in left fork
leg COM (white adjuster).
Grooves are milled into the side of the upper end of the fork
402556-10
legs. The second milled groove (from the top) must be flush
with the upper edge of the upper triple clamp.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
F03182-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp. Mount
and tighten screws
Guideline
F03181-10
Screw, brake line
bracket
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
SERVICE WORK ON THE CHASSIS 12
1
are positioned toward the front.
2
.
M8
20 Nm (14.8 lbf ft)
3
.
M8
15 Nm (11.1 lbf ft)
M8
25 Nm (18.4 lbf ft)
5
.
EJOT
1.7 Nm (1.25 lbf ft)
(
p. 90)
p. 103)
p. 48)
(
p. 89)
(
p. 50)
p. 55)
4
.
Loctite
®
243™
p. 101)
p. 101)
51