12 SERVICE WORK ON THE CHASSIS
68
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides in front of
the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or damaged.
F03212-11
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
F03211-11
–
Position the horn with the horn bracket.
–
Mount and tighten screws
Guideline
Screw, fuel tank spoiler
on radiator
F03210-11
–
Plug in connector
–
Remove the wash cap set.
–
Clean the quick release coupling thoroughly with compressed air.
Info
Under no circumstances should dirt enter into the fuel line.
Dirt in the fuel line clogs the injection valve!
–
Spray silicone spray onto a lint-free cleaning cloth and lightly lubri-
F03208-11
cate the O-ring of the quick-release coupling.
Silicone spray (
–
Join quick release coupling
Info
Route the cable and fuel line at a safe distance from the
exhaust system.
Finishing work
–
Mount the seat. (
p. 74)
1
with the rubber bushing.
M6
10 Nm (7.4 lbf ft)
2
with the collar bushings.
M6
6 Nm (4.4 lbf ft)
3
for the fuel pump.
p. 139)
4
.
p. 60)