Installing The Fork Protector; Removing The Fork Legs; Installing The Fork Legs - GAS GAS MC-E 5 Owner's Manual

13 SERVICE WORK ON THE CHASSIS
13.6
13.7
13.8
44

Installing the fork protector

M01841-11

Removing the fork legs

M01840-10
M01842-10

Installing the fork legs

F02179-10
–
Position the fork protector on the left and right fork leg. Mount and
1
tighten screws .
Guideline
Remaining screws,
chassis
–
Position the brake line and the clamp. Mount and tighten
2
screws .
Guideline
Screw, brake line
clamp on fork
protector
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
1
Remove screws and take off the clamp.
–
2
Remove screws and take off the brake caliper.
–
Allow the brake caliper and the brake line to hang loosely to the
side.
Info
Do not kink the brake line.
–
Note the installation position of the fork legs.
–
3
Loosen screws . Remove the left fork leg.
–
4
Loosen screws . Remove the right fork leg.
Condition
Individual installation position
–
Position the fork legs.
Guideline
Observe the position determined during removal.
1
Bleeder screws
Condition
Standard installation position
–
Position the fork legs.
1
Bleeder screws
M6 10 Nm (7.4 lbf ft)
EJOT PT ® 2 Nm (1.5 lbf ft)
K60x20‑AL
p. 42)
( p. 73)
are positioned toward the rear.
are positioned toward the rear.