GAS GAS EC 350F Owner's Manual page 55

–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red
adjuster).
The compression damping is located in left fork leg COMP
(white adjuster).
Grooves are milled into the side of the upper end of the fork
V01791-10
legs. The second milled groove (from the top) must be flush
with the upper edge of the upper triple clamp.
–
Tighten screws
Guideline
Screw, bottom triple
clamp
F03185-10
–
4
Tighten screw
Guideline
Screw, top steering
head
–
Mount and tighten screw
Guideline
Screw, top steer-
ing stem
F03186-10
–
Tighten screws
Guideline
Screw, top triple clamp
F03185-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp. Mount
and tighten screws
F03181-11
Finishing work
–
Mount the handlebar cushion.
–
Install the front fender. (
SERVICE WORK ON THE CHASSIS 12
5
are positioned toward the front.
6
.
M8 15 Nm (11.1 lbf ft)
.
M20x1.5 12 Nm (8.9 lbf ft)
7
.
M8 20 Nm (14.8 lbf ft)
8
.
M8 20 Nm (14.8 lbf ft)
M8 25 Nm (18.4 lbf ft)
bk
.
p. 56)
Loctite ® 243™
9
.
Loctite ® 243™
53