Checking The Headlight Setting; Adjusting The Headlight Range - GAS GAS EC 350F Owner's Manual

15.9

Checking the headlight setting

15.10

Adjusting the headlight range

–
Position the vehicle upright on a horizontal surface in front of a light
wall and make a marking at the height of the center of the low beam
headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
Guideline
400726-10
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
» If the boundary between light and dark does not meet specifica-
tions:
–
Adjust headlight range. (
Preparatory work
–
Check the headlight setting. (
–
Remove the headlight mask with the headlight. (
Main work
–
1
Turn bolt clockwise.
The headlight range increases.
–
1
Turn bolt counterclockwise.
The headlight range decreases.
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
S04493-10
lower mark for a motorcycle with rider (instructions on how to
apply the mark: Checking the headlight setting).
Info
If you have a payload, you may have to correct the headlight
range.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
ELECTRICAL SYSTEM 15
B
under the first marking.
5 cm (2 in)
A
away from the wall.
5 m (16 ft)
p. 103)
p. 103)
p. 101)
p. 101)
p. 103)
103