Handlebar Position; Adjusting The Handlebar Position - GAS GAS EC 350F Owner's Manual

11 TUNING THE CHASSIS
11.14
11.15
46

Handlebar position

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
On the upper triple clamp, there are 2 holes at a distance of
other.
A
Hole distance
The holes on the handlebar supports are placed at a distance of
from the center.
B
Hole distance
The handlebar supports can be mounted in four different positions.
F03176-10
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place handlebar supports in required position. Mount and tighten
2
screws .
Guideline
Screw, handlebar
holder
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
F03177-10
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Remove the
2
. Take off handlebar supports.
M10 40 Nm (29.5 lbf ft)
A
to each
B
Loctite ® 243™