There Is Flash Point When Output To The Led Screen; App Software Cannot Properly Connected In Mobile Phone Or Tablet Computer; Vga Input Offset Or Cannot Be Full Size Shown - RGBlink VENUS X1 Manual

6.1.3 There is Flash Point when Output to the LED Screen

Frequently Asked
There is flash point when output to the LED screen
Question
Change the DVI Cable
There is flash point on LED display when input sending card. This is because
the DVI cable quality of good and bad are intermingled. Please change the
DVI cable and test again.
Troubleshooting Change the DVI Output Port
The DVI output port is loose or oxidation due to plug and pull frequently or
long time no use, which may cause the signal attenuation. There are two DVI
output ports on VENUS X1, please change to the other DVI output port and
test again.
6.1.4 APP Software cannot Properly Connected in Mobile
Phone or Tablet Computer
Frequently Asked

APP software cannot properly connected in mobile phone or tablet computer

Question
Confirm if Open the Ethernet Function
Confirm if the second icon on the OLED module is @, if not, the ethernet
function of device is not open. Push the [MENU] button, then select
<SYSTEM>, turn the knob and select <ETHERNET>, set the <NETWORK>
as "ON" in the submenus.
Troubleshooting
Confirm if IP Conflict for Mobile Phone, Wireless Router and Device
System default the device IP is 192.168.0.100, please check if the IP of
wireless router is inconsistent with this IP, the IP will conflict if consistent,
and unable to search the device and normal connection. Please change the
device IP address, and make sure it is in the same network segment.

6.1.5 VGA Input Offset or cannot be Full Size Shown

Frequently Asked
VGA input offset or cannot be full size shown
Question
Set Auto Adjust for VGA Input
Long push the [VGA] button and enter to the <VGA ADJUST>, the auto
adjust time is about 10 seconds. Or push the [MENU] button, then choose
Troubleshooting <INPUT>, turn the knob and select <VGA ADJUST>, push the knob to
confirm. Turn the knob and select <AUTO ADJUST>, the auto adjust time is
about 10 seconds. If auto adjust cannot solve the problem, please manually
adjust in <VGA ADJUST>.
65