Advertisement
5-18
C
5: M
HAPTER
AINTENANCE AND
U
PGRADES
2 Place the cover on the chassis.
To ensure correct placement, be sure that the panel with the greater
number of ventilation holes is positioned on the left side (viewed from the
front of the server).
3 Using the #1 Phillips screwdriver, tighten the screws on each side of the
cover until snug. Do not overtighten.
If you are remounting the server in a rack, replace the middle screw only. If
you are mounting the server on a tabletop, replace all three screws.
4 Recable any connectors whose cables have been removed.
5 Reinstall any strain reliefs that have been removed.
Figure 2-11 on page 2-15 shows how the strain relief mechanism is installed.
6 If your server was mounted in a rack, replace the rack-mounting brackets on
the sides of the server and remount the server in the rack.
Refer to Figure 2-4 on page 2-8 to see how the server is mounted in a rack.
7 Make sure the AC power switch is in the O or off position.
8 Attach the power cord to the receptacle on the back panel.
9 Plug the other end of the power cable into an AC power source.
10 Power on the server.
Advertisement
