Advertisement
Installing
Ethernet
Interface Modules
6 Fasten the panel with the two screws.
7 Replace the cover.
WARNING: To avoid a fire hazard, always replace the cover. Operating the
server without a cover can cause it to overheat and will void the warranty.
a Place the cover on the chassis.
Make sure that the panel with the greater number of ventilation holes is
positioned on the left side (viewed from the front of the server).
b Using the #1 Phillips screwdriver, replace and tighten the black screws on
each side of the cover until snug. Do not overtighten.
If you intend to mount the server in a rack, replace the middle screw only.
If you intend to use the server on a tabletop, replace all three screws.
To cable the 16-port asynchronous modules to a host, terminal, modem, or
other serial equipment, refer to "Cabling 16-Port Asynchronous Modules".
This section describes the procedure for installing an Ethernet interface
module. Instructions for cabling the modules are provided in "Cabling
Ethernet Interface Modules".
WARNING: Be sure the unit is turned off and the power cable is either
unplugged from the unit or from the wall socket.
You need a #1 Phillips screwdriver. To install an Ethernet interface module,
follow these steps:
1 Insert the Ethernet interface module into the slot.
a Hold the module with the component side up and the connector
mounted on the edge of the board away from you.
b Slowly slide the module into the slot, being careful to align the board
edges with the guide rails in the chassis, as shown in Figure 2-3.
Installing Ethernet Interface Modules
2-5
Advertisement
