CAUTION: To eliminate cable noise emission in excess of FCC Part 15 Subpart
J, or CISPR22 (EN55022) for Class A devices, the console cable should be
triple-shielded (Inmac 536888 or equivalent) and have connectors with
metallic backshells. Cable shields should be connected to backshells.
For wiring information for the console port connector, refer to Appendix A,
"Pin Assignments."
To attach a console, follow these steps:
1 Attach one end of the cable to the console port on the back panel of the
communications server and the other end to the modem port on the back
of a terminal (see Figure 2-13). If you are using a PC with emulator software,
attach the other end to the PC's serial port.
Back of terminal
Figure 2-13 Attaching Terminal to Console Port
2 Verify that the terminal's configurable parameters match the settings in
Table 2-4.
J11
J10
INTFC
• • • • • • • • • • • • •
• • • • • • • • • • • •
CONSOLE
AUXILIARY
PARALLEL PRINTER
J1
RS-232C
J2
J1
Attaching a Console
J13
J15
J12
J14
• • • • • • • •
• • • • • • •
J4
2-19