Advertisement
2 Type
to display current parameter settings.
D
The following display shows factory default settings for the CS/3100 (except
for the interface address, which is only an example):
Current Parameters:
Interface address:
J1 baud rate:
J2 baud rate:
Continuous self-test:
Auto-reboot:
Initial boot source:
Number of reboots:
Network boot string:
Boot retries:
Boot protocol:
Change IP/TFTP parameters:
Memory Test By-pass:
esc - Return to previous menu
Default settings for the CS/3000 are the same, except that the initial boot
source is "Network."
3 To return to the Firmware Configuration Utility menu, press the Escape key.
4 To change the current parameters, type
The Change Parameters menu appears:
Current Parameters:
1. J1 baud rate:
2. J2 baud rate:
3. Continuous self-test:
4. Auto-reboot:
5. Initial boot source:
6. Number of reboots:
7. Network boot string:
8. Boot retries:
9. Boot protocol:
A. Change IP/TFTP parameters:
B. Memory Test By-pass:
esc - Return to previous menu
Select parameter ?
5 Type the number or letter for the parameter you want to change.
Table 4-1 describes each parameter and the choices available. More detailed
descriptions of each parameter follow this table.
Changing the Configuration
08000203A89A
9600
9600
Disabled
Reboot only
Floppy
00
_cs30
Try Forever
SLP
Disabled
.
C
9600
9600
Disabled
Reboot only
Floppy
00
_cs30
Try Forever
SLP
Disabled
4-3
Advertisement
