Advertisement
CAUTION: Procedures that involve removing the server cover must be
performed by service personnel only.
"Service personnel" means people who have appropriate technical training
and experience. Service personnel are aware of possible hazards and of ways
to minimize the danger to themselves and others.
You need a #1 and a #2 Phillips screwdriver. To install the 16-port
asynchronous module, follow these steps:
WARNING: Before removing the cover, be sure the unit is turned off and the
power cable is either unplugged from the unit or from the wall socket.
1 Remove the cover.
a Using the #1 Phillips screwdriver, remove the three black screws from
each side of the cover.
b Grasp both sides of the cover and carefully lift it off.
2 Remove the upper portion of the back panel.
Using the #2 Phillips screwdriver, remove the two screws located at the
outer edges of the upper portion. Then remove the panel as shown in
Figure 2-1.
Upper panel
Figure 2-1 Removing Upper Portion of Back Panel
Installing 16-Port Asynchronous Modules
2-3
Advertisement
