Advertisement
5-10
C
5: M
HAPTER
AINTENANCE AND
Replacing the
Diskette Drive
16-port asynchronous modules
U
PGRADES
This section explains how to replace the diskette drive (Model CS/3100 only).
You need a #1 and a #2 Phillips screwdriver. Follow this procedure:
1 Make sure server power is off and the power cord is unplugged.
2 Remove the cover, as described in "Removing the Cover".
3 Disconnect the ribbon cable and power wiring harness from the connectors
on the rear of the diskette drive. Fold the cables so they are out of the way.
Figure 5-6 shows the location of the ribbon cable and power wiring harness
connectors. Note the orientation of the ribbon cable.
Front panel
Figure 5-6 Location of Ribbon Cable and Power Wiring Harness Connectors
Back panel
Cable clamp
Power supply
Screw
Ribbon cable
connector
Power wiring
harness
connector
Diskette drive
Advertisement
