3Com CS/3000-48 Installation Manual page 52

4-4 C 4: C
HAPTER ONFIGURATION
6 When you are finished changing firmware configuration parameters, press
the Escape key to return to the Firmware Configuration Utility menu.
7 Press the Escape key again to exit to the monitor prompt.
8 Press the reset switch or power off the server to exit monitor mode.
Table 4-1 Firmware Configuration Parameters
Parameter
1. J1 baud rate
2. J2 baud rate
3. Continuous self-test
4. Auto-reboot
5. Initial boot source
6. Number of reboots
7. Network boot string
8. Boot retries
9. Boot protocol
A. Change IP/TFTP parameters See "Change IP/TFTP Parameters".
B. Memory test bypass
* Default.
Values
1. 110
2. 300
3. 1200
4. 2400
*
5. 9600
6. 19200
7. 38400
1. 110
2. 300
3. 1200
4. 2400
*
5. 9600
6. 19200
7. 38400
*
d - Disable
e - Enable
m - Boot monitor
r - Reboot only *
u - Upload then reboot
a - Auto *
f - Floppy
m - Monitor
n - Network
r - Reset
*
_cs30
O - Try One Time
F - Try Forever *
B - BTP Boot
S - SLP Boot *
T - TFTP Boot
*
D - Disable
E - Enable