Advertisement
Command
Descriptions
Table 6-1 Firmware Commands
Command
Function
BS
Boots from the source specified in the Network Boot String parameter.
BT
Boots from a specified source, overriding the source specified in Initial Boot Source parameter.
*
CO
Copies the contents of one diskette inserted in the disk drive to another diskette.
*
DE
Deletes the specified file from the diskette.
DF
*
Displays files on the diskette.
*
DU
Dumps the server's memory to a set of diskettes.
FC
Enters the Firmware Configuration Utility Commands menu.
*
FO
Formats a diskette.
H or ?
Displays a list of commands and their syntax.
K
Performs a soft reset of the server.
RS
Resets the server.
SW
Toggles between user command help menu and diagnostic command help menu.
UP
Uploads memory to the hard disk of an RBCS or TFTP server on the network.
!
Repeats the last command.
* Model CS/3100 only.
Syntax
Description
Syntax
Description
Table 6-1 summarizes monitor mode commands. You can enter commands
in either upper- or lowercase at the angle bracket prompt. Detailed
descriptions of the commands follow the table.
BS
BS
Boots the server from the source specified in the Network Boot String
parameter. To reconfigure this parameter, refer to "Network Boot String".
BT
BT
BT <filenumber>
BT <filename > < address >
Boots the server from a specified source, overriding the Initial Boot Source
parameter.
Using Commands
C-5
Advertisement
