Advertisement
2-6
C
2: I
HAPTER
NSTALLATION
Mounting the
Server
Mounting on a
Tabletop
Figure 2-3 Installing the Ethernet Interface Module
c Continue to slide the module into the slot until you feel a slight
resistance.
This resistance is caused by the connector on board engaging the
connector on the motherboard.
2 Fasten the module into the chassis with the two screws.
You can mount a CS/3000 series server on a tabletop, in a two- or four-pole
19-inch rack, or vertically in a wall mount. It is usually easier to mount the
server before attaching cables
To mount your server on a tabletop, use the following procedure:
1 Place the server on a firm, flat surface.
Do not mount the server at an angle greater than 15 degrees from the
horizontal or vertical.
2 Make sure that the air intake and fan exhaust vents on the sides of the
cover are not blocked.
Leave at least 5 inches (13 cm) of free space on both sides.
Advertisement
