Outputs - Extron electronics PVS 407D User Manual

Inputs 5 and 6
B
sources (such as an Extron ShareLink device) to these female HDMI digital video
connectors. Use the Extron LockIt device to secure the HDMI cable at the switcher
(see Securing the HDMI Cable
Input 7
C
analog audio signal from an output source such as an iPod or an MP3 player.
Connect a cable from the source to this 5-pole captive screw connector. It can be
wired as balanced or unbalanced (see
wiring details).
Aux audio port
D
connector for dedicated mono audio only input.
VoiceLift port
E
VLR 302 VoiceLift Receiver for integration of a VoiceLift Microphone system.
NOTE: To install the VoiceLift Microphone system, see the VoiceLift Installation
Guide, supplied with the device.
Paging sensor port
F
PPS 25) to this port, to enable program audio interruptions during paging system
broadcasts.
NOTE: The Extron Priority Page Sensor is an optional accessory, purchased
separately. See the Extron
To install a Priority Page Sensor system, see the installation guide supplied with
the applicable device.

Outputs

HDMI video output
G
video output connector. Use the Extron LockIt device to secure the HDMI cable at the
switcher (see
Line out audio output
H
assisted listening device to this 3.5 mm captive screw 5-pole connector.
Amplified audio output
I
connector. The amplified audio is capable of outputting 50 watts (2 x 25 watts RMS)
for 4 and 8 ohm speakers (see
details).
(see figure 3 on the previous page) — Connect up to two HDMI
on page 9 for securing the cable).
— Input 7 is a dedicated audio-only input for an auxiliary, stereo, line-level
— Connect an aux audio device to this 3.5 mm captive screw 3-pole
— This RJ-45 jack is dedicated for use with the optional VLR 102 or
— Connect the optional Priority Page Sensor (PPS 35 or
website
— Connect a suitable display device to this female HDMI digital
Securing the HDMI Cable
— Connect an external amplifier, recording, podcasting, or
— Connect speakers to this 5 mm captive screw 4-pole
Speaker Configuration
PVS 407D Switcher • Rear Panel Connections
Input 7 Connector Wiring
for details about the Priority Page Sensors.
on page 9 for securing the cable).
on page 56 for wiring
on page 63 for
6