Table of Contents
Advertisement
Cable routing
5.3
Maximum power consumption
7050
Pump - Motor unit
Magnet (hydraulic unit)
Magnet (electric safety valve)
Solenoid
Minimum recommended cable area
(apply copper cable, plus- and minuscable)
Control cable
Main cable, L < 8m
Main cable, L = 8 - 15m
Main cable, L > 15m
Battery
Min.
, I
capacity
min
Min. voltage, U
min
I
min
-
+
I
min
-
+
Image 57. Calculation of minimum conductor cross sectional area
5.2
Battery maintenance
When storing for longer than 1 week, you are recommended to disconnect the lift from the battery via the main
switch or by releasing the lift's main fuse, in order to reduce the risk of the battery discharging. The length of
time the vehicle can be stored without the battery's charge level becoming too low depends on the condition of
the battery, the charge level before storage and how much power the vehicle's other components take from the
battery. After a period of storage, the battery must always be charged fully before operating the lift.
When installing the lift and when carrying out service and repair work, when the lift is operated repeatedly
without the vehicle being started and used, the battery charger must be used between operations to main-
tain the battery's charge level.
NOTE!
The battery charger must not be connected when operating the lift. Risk of damage.
www.zepro.com
ZAHD, ZAEHD 150/200-155/175 (200 bar)
12 volt
1,5 mm
(At lift)
L
24 volt
245 A
135 A
4,2 A
2,1 A
1,5 A
0,75 A
1,5 A
0,85 A
1,5 mm
2
2
35 mm
35 mm
2
2
50 mm
35 mm
2
2
-
50 mm
2
180 Ah
170 Ah
9 Volt
18 Volt
U
min
L
ZAHD, ZAEHD 150/200-155/175
NOTE!
Ensure that the lift has access
to the minimum recommended
power capacity (I
). Some
min
vehicles have restrictions
regarding the amount of power
the lift can access from the
existing battery.
U
min
35
Advertisement
Table of Contents
