Table of Contents
Advertisement
Installation
6.2
Control power cable
NOTE.
See also the relevant vehicle manufacturer's
electrical instructions
1. If the control power cable is not pre-routed, e.g.
VDHH, route the control power cable from the
driver's cab to the lift.
NOTE.
The cable must be protected with rubber grom-
mets when it passes through beams or walls.
Position any quick connectors so they are well
protected from moisture and dirt.
2. Connect the control power cable to the cab
switch (CS) on the vehicle instrument panel.
Connect to the on-board electrical system via
a 10 A (24 V), 15 A (12 V) fuse according the
customer's wishes. See the connection diagram
"8.6 Connecting controllers" on page 40.
www.zepro.com
Image 19. Quick connectors must be well protected
Z 10/15/20
19
Hide quick links:
Advertisement
Table of Contents
