Installation
6.2
Control power cable
NOTE.
See also the trailer manufacturer's electrical instructions.
1. Route the control power cable from the driver's cab to the lift.
NOTE.
The cable must be protected with rubber grommets when it passes through beams or walls. If there
are quick connectors, make sure they are effectively protected from moisture and dirt. Do not bend the
cable to too small a radius as this can cause damage to the cable.
2. Connect the control power cable to the cabin switch (CS) on the vehicle instrument panel. Connect to the
on-board electrical system via a 10 A (24 V), 15 A (12 V) fuse according the customer's wishes. See the
connection diagram "9.8 Connecting cabin switch and open platform alarm" on page 42.
www.zepro.com
ZHD 2500-130/150
19