Changing Filament While Printing - Bresser RAPTOR Instruction Manual

④ Clean the extruded filament, rotate the Knob until the Continue option is
highlighted, then press the Knob to resume printing.

Changing Filament While Printing

① With the Printing... Screen displayed, press the Knob to display the Print Control
② Rotate the Knob until the Pause Print option is highlighted, then press the Knob to
Menu.
③ Rotate the Knob until the Auto Retract Filament option is highlighted, then press
pause the print. The printer will finish the current layer, then will pause printing.
④ Once the filament has been unloaded, replace the spool of filament on the
the Knob to start the Unloading Filament process.
⑤ Using a pair of scissors or side cutters, cut about an inch off the end of the filament,
Filament Holder with a new spool of filament.
then gently straighten the end of the filament. Squeeze the lever on the Extruder,
insert the filament into the bottom until you encounter resistance, then release the
lever.
⑥ Rotate the Knob until the Auto Feed Filament option is highlighted, then press the
Knob to start the Loading Filament function. The Nozzle will heat to the target
temperature, if necessary, then will load the filament and extrude a small amount.
Clean the extruded filament.
⑦ Rotate the Knob until the Continue option is highlighted, then press the Knob to
continue printing with the new filament.
www.bresser.de
35