Adjusting Target Temperature; Z Offset Setting - Bresser RAPTOR Instruction Manual

Adjusting Target Temperature

The Target Temperature is the temperature to which the printer will heat the Nozzle. By
default, the Target Temperature is set to 210°C.
① On the Main Menu, rotate the Knob until the Control option is highlighted, then
② Rotate the Knob until the Temperature option is highlighted, then press the Knob to enter
press the Knob to enter the Control Menu.
③ Rotate the Knob until the Nozzle option is highlighted, then press the Knob to edit the value.
the Adjust Temperature Screen.
④ Rotate the Knob to change the Target Temperature, then press the Knob to save the
value.

Z Offset Setting

The Z Offset Setting is used to adjust the distance between the Nozzle and the Print
Bed. This can be done before printing or during printing. If the distance between the
Nozzle and the Print Bed is too small, increase the Z Offset. if the distance between the
Nozzle and the Print Bed is too large, decrease the Z Offset. The proper distance
between the Print Bed and the Nozzle is when there is a slight amount of resistance
when moving a piece of ordinary printer paper between the Nozzle and the Print Bed.
If you changed the Z Offset prior to printing, turn the printer off and then back on to
save the setting as the default.
www.bresser.de
28