General settings
Loading/Unloading the filament
Manual
Print
Preheat
Tools
1. Tap on [Tools] > [Filament]
R Extruder
Heating...
2. Tap on [Load] to start the extruder heating up. After the target temperature is
reached, manually insert the filament into the filament feeding wheel. When the
filament is ejected from the nozzle, it indicates that loading is completed.
2. Tap on [Unload] to start the extruder heating up. After the target temperature
is reached, manually feed out a part of filament from the nozzle. Then at the same
time press down the spring presser and quickly pull out the filament.
- 10 -