Bresser RAPTOR Instruction Manual page 17

(3-9) Press the Knob to start loading filament. Once filament starts extruding from the
Nozzle, press the Knob again to stop extrusion, then press the Knob to select the
Continue option.
(3-10) Remove the included microSD™ card from the Accessory Box, then insert it
into the microSD card slot to the left of the LCD Screen. Press the Knob to select
Next on the wizard.
(3-11) Press the Knob to select Print From SD. Rotate the Knob to highlight a .gcode
file on the microSD card, then press the Knob to begin printing the highlighted model.
(3-12) Once the print is finished, remove the Magnetic Print Bed from the metal print
platform, then bend it to remove the model. Replace the Magnetic Print Bed on the
metal print platform.
www.bresser.de
3-8
3-9
3-10
3-11
17