Connect To Wi-Fi - Bresser RAPTOR Instruction Manual

① On the Main Menu, rotate the Knob until the Control option is highlighted, then
② Rotate the Knob until the Z Offset Setting option is highlighted, then press the
press the Knob to enter the Control Menu.
Knob. The printer will test the distance from the Nozzle to the Print Bed in several
places to determine the current Z offset. When it is done testing, the Adjust Z
③ Place a sheet of ordinary printer paper between the Nozzle and the Print Bed.
Offset Screen is displayed.
Rotate the Knob to adjust the Z offset until there is a slight amount of resistance
④ When the proper Z offset is set, press the Knob to return to the Control Menu.
when moving the paper around between the Nozzle and Print Bed.
Connect to Wi-Fi®
Note that the printer does not support 5G Wi-Fi® networks and cannot connect if
① On the Main Menu, rotate the Knob until the Control option is highlighted, then
there are already 10 or more Wi-Fi connections.
② Rotate the Knob until the Wi-Fi Network option is highlighted, then press the Knob
press the Knob to enter the Control Menu.
③ Rotate the Knob until the Connect to Wi-Fi option is highlighted, then press the
to enter the Wi-Fi® Network Menu.
④ Download and install the PoloPrint app from the microSD card. During installation,
Knob to display the Connect to Wi-Fi Screen.
the app will ask for permissions to access Storage and Location information. Slide
the controls to the right to allow access, then touch DONE to continue.
www.bresser.de
29