Insert The Filament Guide Tube; Load Filament Screen - Bresser RAPTOR Instruction Manual

(3-5) Insert the Filament Guide Tube into the black pneumatic connector on top of the
Extruder.
(3-6) Ensure that the power switch on the inline control on the AC Power Adapter is
in the OFF position (O). Plug the DC barrel connector on the AC Power Adapter into
the Power Port on the right side of the printer. Plug the included AC Power Cord into
the AC Power Adapter, then plug the other end into a nearby AC power outlet.
(3-7) Flip the power switch on the inline control to the ON position (I). After the printer
finishes booting, you will see the following wizard. Depress the Knob on top of the
printer to select Next on the Welcome Screen, then again to select Next on the STEP

1: LOAD FILAMENT Screen.

(3-8) Using a pair of scissors or side cutters, cut about an inch off the end of the
filament, then gently straighten the end of the filament. Squeeze the lever on the
Extruder, insert the filament into the bottom until you encounter resistance, then
release the lever.
www.bresser.de
3-5
3-6
3-7
16