8
8.5.2 Replacing the SCSI Cable/Backplane
8-18
.
Cable clips
SCSI cable
Figure 8-15 Removing the SCSI Backplane
9. Remove the SCSI backplane from the bracket.
See Figure 8-15.
1. Route the SCSI cable under the three cable clips in the base of the chassis
and through the opening near the front edge of the system board.
See Figure 8-15.
2. Connect the SCSI cable to the system board at J2602.
3. Position the SCSI backplane on the disk drive bay so the SCSI backplane
slots sit on the tabs.
See Figure 8-16.
Sun Ultra 1 Series Service Manual—November 1995
Disk drive bay
J2602
SCSI
backplane