Table of Contents
Advertisement
2. Hold the NVRAM/TOD carrier on both ends and lift it straight up.
Gently wiggle the NVRAM/TOD as necessary.
3. Place the NVRAM/TOD with its carrier on an antistatic surface.
10.2.2 Replacing a NVRAM/TOD
1. Position the replacement NVRAM/TOD on the system board.
See Figure 10-9.
2. Carefully insert the NVRAM/TOD into the socket.
The carrier is keyed so the NVRAM/TOD can be installed only one way.
3. Push the NVRAM/TOD into the carrier until it sits tightly in the socket.
System Board and Component Replacement
10
10-11
Advertisement
Table of Contents
