9
9.2.2 Removing a CD-ROM/Tape Drive
9.2.3 Replacing a CD-ROM/Tape Drive
9-8
1. Position the bracket on top of a flat surface, so that the CD-ROM/tape
drive is flat.
See Figure 9-7.
Figure 9-7
Positioning the CD-ROM/Tape Drive
2. Remove the four screws securing the CD-ROM/tape drive to the drive
bracket.
See Figure 9-7.
3. Remove the CD-ROM/tape drive, and place it aside.
1. Position the CD-ROM/tape drive on an antistatic surface. Align it on the
edge of the surface.
See Figure 9-7.
2. Position the bracket on top of the CD-ROM/tape drive. If your system has
a diskette drive, it is assembled on the bracket.
3. Replace the four screws to secure the CD-ROM/tape drive to the bracket.
Sun Ultra 1 Series Service Manual—November 1995
Screws
4 places
Bracket
CD-ROM/tape
drive