Figure 9-9 Positioning The Drive Bracket In The Chassis - Sun Microsystems Ultra 1 140 Service Manual

9
9-10
5. Position the bracket in the chassis, and slide it toward the opening in the
side of the chassis. The hooks in the base of the chassis must lock into the
holes in the bottom of the drive bracket.
See Figure 9-9.
Holes (3)
Figure 9-9 Positioning the Drive Bracket in the Chassis
6. Connect the DC harness to the peripheral power cable at P1.
See Figure 9-5.
7. Route the DC harness through the clip on the bracket.
8. Tighten the two screws on the chassis.
Sun Ultra 1 Series Service Manual—November 1995
Bracket
Chassis
P1
Clip
Screws