8
8-30
Note – If the system contains a CD-ROM or a tape drive, go to Steps 5
through 8. Otherwise, you are done replacing the fan/speaker cable.
5. Position the bracket assembly into the chassis, and slide it toward the
opening in the side of the chassis. The hooks in the base of the chassis
must lock into the holes in the bottom of the drive bracket.
See Figure 8-27.
6. Connect the DC harness to the peripheral power cable at P1.
7. Reroute the DC power harness through the clip on the bracket.
8. Replace the two screws to secure the drive bracket to the chassis.
Sun Ultra 1 Series Service Manual—November 1995