9
9.1 Disk Drive
9.1.1 Removing a Disk Drive
9-2
1. Remove the EMI door.
a. Use a screwdriver to open up the EMI door.
See Figure 9-1.
b. Remove the door from the chassis.
You must replace it after the new drive is installed.
Figure 9-1
EMI Door
2. Locate the defective disk drive.
Your system might have more than one disk drive.
Note – If you remove more than one disk drive, take note of the slot each drive
was installed into. The SCSI target addresses for the drives are assigned based
on the drive's position. The SCSI target address for the lower drive slot is 0,
and the upper drive slot is 1.
Sun Ultra 1 Series Service Manual—November 1995
Chassis
EMI Door